Skip to main content

How To Use the ID Verification Feature

The ID Verification Feature lets visitors prove who they are through the registration portal, before they arrive onsite. It asks them to scan their ID and also check it against a live selfie before letting them complete the registration process.
​

As part of registering, the visitor scans their ID and takes a selfie. The two are matched, the document is checked, and the visitor gets a Pass or Fail result. Your registration experience then sends them down the path you designed for that result.

You can also choose to keep certain details read from the ID, such as name, date of birth, document number and expiry date, etc. Those details are saved with the visit, so admins can see what data was captured alongside the pass/fail result.
​
This feature is powered by Socure. Their Terms of Use and Privacy Notice are linked below:

What your visitor sees

  1. The visitor opens their invite or registration link and starts registering.
    ​

  2. They fill in the earlier pages, including their name.
    ​

  3. They reach the Identity Verification page.

    • On a mobile device, verification starts right on that page and uses the device camera.
      ​
      ​


      ​

    • On a laptop or desktop, they see a QR code to scan with their phone, and they finish the verification on the phone. Phone cameras scan documents much more reliably than webcams.
      ​
      ​


      ​

  4. They tap Start verification and give their consent.


    ​


    ​

  5. They pick the type of ID they're using (eg. Passport or Driver's License) and photograph it.
    ​

  6. They take a live selfie.
    ​
    ​


    ​

  7. The result comes back within a few moments, and the visitor moves on automatically to the next page set for Pass or Fail.

Tip for your visitors: Glare is the most common reason a scan takes more than one try. A flat surface, even lighting and no direct overhead light all help.

Setting it up

The ID Verification page can be set up in the Registration Experience Editor.

Add the page

  1. Open a Registration Experience Editor
    ​

  2. Add the Identity Verification Page.
    ​
    ​


    ​

    Collect the name first. The verification checks the ID against the name entered earlier, either by the visitor in the registration portal or by the host when creating the invite. If the name hasn't been collected yet when the visitor reaches this page, the verification can't run.
    ​
    Ensure your Identity Page appears anywhere before the ID Verification Page


    ​

  3. Customise the visitor-facing text: Page message, Page sub-message, Next button text and Back button text.
    ​

  4. If you wish, choose which ID details to capture from the ID. By default, nothing is saved except for the PASS/FAIL status. These include:

    • First Name

    • Last Name

    • Last Name

    • Document Number

    • Date of Birth

    • Issue Date

    • Expiration Date

    • Address
      ​


    ​

  5. Set up the outcomes:

    • Add a Pass branch and point it at the page a verified visitor should see next.

    • Add a Fail branch and point it at your failure path. For example, this could be a "please contact your host" page or a page explaining that registration can't continue.

  6. Save and publish the experience in your Location.

Where to see the results

Once a visitor completes verification, each record shows the Pass/Fail result and the captured details you chose to collect. This is visible in the Invite record or Guestbook record, when opening up a visitor's details.
​
In the Invites section, click the View button under the Registration column.

In the Guestbook, click the visitor's name > Details > expand Registration Information

Did this answer your question?